vMix Forums
»
General
»
General Discussion
»
Monitor master and bus audio in headsets
Rank: Member
Groups: Registered
Joined: 6/13/2020(UTC) Posts: 14  Location: Atlanta, GA
|
Can you monitor master audio and a bus (say A bus) in headsets during production? Would like to hear a remote producer through vmixcall but don't want them on the program recording. Is this possible?
Thank you!
|
|
|
|
|
|
Rank: Advanced Member
Groups: Registered
Joined: 2/23/2019(UTC)
Posts: 556
Thanks: 62 times
Was thanked: 130 time(s) in 118 post(s)
|
One way could be: Set up another Bus (B), send your M and A inputs also to Bus B, solo Bus B with the S button.
|
|
|
|
|
|
Rank: Newbie
Groups: Registered
Joined: 8/29/2020(UTC) Posts: 6 Was thanked: 1 time(s) in 1 post(s)
|
Originally Posted by: dmwkr  One way could be: Set up another Bus (B), send your M and A inputs also to Bus B, solo Bus B with the S button. Why not just remove the headphones from "headphones", assign them as the audio device for bus B instead, then add anything you want to monitor to bus B? Personally, I found the fader easier to adjust than the headphone knob, so I did that anyway a while back--not sure why it wouldn't work here.
|
|
|
|
|
|
vMix Forums
»
General
»
General Discussion
»
Monitor master and bus audio in headsets
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
Important Information:
The vMix Forums uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
