Hi Folks,

Quick question - what am I doing wrong with my audio setup? Whenever I go to a specific audio input and I turn down that input's headphone mix, it does not have any effect and I still hearing that input in my headphone.

I'm using a Behringer UMC404HD digital audio interface, and this is how I have things routed (see screenshot as well):

• vMix Master --> Default Playback Device

• vMix Headphone --> Wireless Headphone

• vMix Bus A --> Main Out L/R

• vMix Bus B --> Line 1 (Virtual Audio Cable)

During my production, I often set the default playback device of the computer to the Wireless headphone so that I can monitor things in my headphone. But now that I'm writing this out, I'm wondering if perhaps I'm shooting myself in the foot by doing this.

Would I be better off explicitly setting the Master bus to None, since I already have Bus A routing audio to the Main Out L/R of the UMC404HD?

Select the output to send the Master audio mix to. This is the default audio mix
used for streaming, recording and external output.

Select the output to send the Headphones audio mix to.
This mix is the same as Master Output except when Solo is enabled on an input.
When Solo is enabled on an input only that input will be heard.

https://www.vmix.com/hel...ex.htm?AudioOutputs.html