vMix Forums
»
General
»
Hardware Compatibility
»
Blackmagic Decklink Duo 2 and Sony EVI-HD1
Rank: Member
Groups: Registered
Joined: 9/7/2015(UTC)
Posts: 11
Location: Maryville, TN
|
I have just bought a new BM Duo 2 in order to upgrade our church livestream to HD. I also have bought the Sony EVI-HD1 camera to provide the feed. I have the camera set to system setting 1, outputting 1080p29.97 and have the vMix camera input set to the same settings. I have the camera plugged into input 1 via SDI (I have also tried other inputs) of the Duo 2, but I CANNOT get a picture! I have the latest BIOS and software installed, I even tried going down to BM Video Desktop Video Setup version 10.8.1 after researching there, all with no luck.
I have an old Osprey e100 that we used for SD, and when I set the camera to mode 4 (NTSC LB) and switch from SDI to the RCA input going to the Osprey capture, I get a picture. ANY help would be appreciated! Thanks!
Windows 10 running on an i7 4 Ghz, 16 GB Ram
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 9/7/2015(UTC)
Posts: 11
Location: Maryville, TN
|
OK, I'm going to post what I found to prevent other noobs like me from wasting a day.....it was the cable. I had bought some cheapo "survailence cable" off Amazon that was supposed to work with all cameras, and able to carry up to 4k signals.....WRONG! I got some good quality cabling, and it works like a champ! Thanks for looking, and if you are having problems, use 75 ohm RGB cable!!!
|
|
|
|
|
|
vMix Forums
»
General
»
Hardware Compatibility
»
Blackmagic Decklink Duo 2 and Sony EVI-HD1
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
Important Information:
The vMix Forums uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
