Hello.

Sorry, for maybe stuped question, but yesterday I obtained Shuttle Pro for Replay. Played with it 15 min. and started customize shortcuts, provided by template. I found allmost everything I need, excepting one feature (probably I did not found it yet). I want to update in and out points of selected event with controller. For example:
1. Some command like “Jump to in point”.
2. When I see exact in point, i can correct it with jog wheel and shuttle. In a points search mode shuttle could work like in a old Betacam VTR’s. It would be great!
3. When I’m in the right place, I can innitiate command “update in point” and voila!... your event is ready for replay :)

It’s not posible in way like this, or I just not found it yet?
Thankyou for replays ;)

My english is not so good, so you missunderstood what I want to say. I will try once again :)

Let’s say I made a shorcut to mark 5 seconds episode in recorder video. I did that let’s say on timecode 0:00:07:00. In that situation my in point will be marked at TC 0:00:02:00 and out point at TC 0:00:07:00. Now I want to check and maybe correct my out point with actual image. There is no function to jump “cursor” in TC 0:00:07:00. On display I see both timecodes - In/Out point and cand drag them with mouse. My goal is not use mouse, but due In/Out corrections with controller.

To mark episode with 5 seconds range I can map button to function “ReplayMarkInOutRecorded” with value 5.
To correct In point TC, I can use function “ReplayMoveSelectedInPoint”.

But how the hell I can jump to that In Point to scroll forward or backward?!

I need something like “JumpToInPoint”, because I need rewind exactly 5 second backward and then I can start search for exact point where i want to start my replay. When it’s done I need to forward 5 seconds, to search, where my out point should be. Scenario:

1. JumpToInPoint - cursor jumps to TC 0:00:02:00. I see the picture, rotate jogweel backwards and decided to start 15 frames earlier.
2. ReplayMoveSelectedInPoint - now my in point TC is 0:00:01:35 (I’m talking about 50FPS production).
3. JumpToOutPoint - cursor immediately jumps to TC 0:00:07:00. Now I can adjust Out Point position in the same way - rotate jogwheel, find a right place, initiate command ReplayMoveSelectedOutPoint.

That’s what I need.