vMix Forums
»
General
»
Hardware Compatibility
»
camera doesn't connect through an HDMI splitter
Rank: Newbie
Groups: Registered
Joined: 3/21/2018(UTC)
Posts: 1
|
Hi, first of all sorry about my english. I'm having some troubles adding a camera input trough an hdmi splitter (i use the splitter to duplicate the signal from a Sony Handycam to a field monitor and to the capture device at the same time). The thing is when i add the camera, an error message appears "AddNewInput. The following are supported: 1920x540". There is no issue when i work with the capture device software (ElGato), where i can see the video signal fine. So i'm sure there the problem only has to do with Vmix. The camera connects fine without the splitter, but it seems the splitter divide the signal from 1920x1080 to 1920x540 and Vmix goes crazy with it. Please help!
|
|
|
|
|
|
Rank: Advanced Member
Groups: Registered
Joined: 7/1/2015(UTC) Posts: 1,151   Location: Houston TX Thanks: 319 times
Was thanked: 263 time(s) in 233 post(s)
|
The fact that it reports the video as 1920x540 tells you that something in the signal chain doesn't support interlaced video. That's why it reports half the vertical resolution.
Which El gato capture device? CamLink did not support 1080i until very recently. It requires a firmware update installed via the El Gato capture software to support 1080i sources.
|
|
|
|
|
|
vMix Forums
»
General
»
Hardware Compatibility
»
camera doesn't connect through an HDMI splitter
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
Important Information:
The vMix Forums uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
