vMix will need to be set to Listener mode for SRT, as Larix does not connect using Rendezvous

I go to general settings and make vMix listener
Then I create and input and set this as well to listen with the same port. (Most of the time I get an error listening on SRT socket message) but after trying various time
and clearing old settings it will accept the input.
But then, still no feed being received from Larix....

thank you. when I connected it to the local network. It worked.
But still not when I want to connect from the "outside" network.
Any ideas?

Thanks very much. I have a couple of meetings coming up, so I will first try again with the manual you sent.
If I still have issues, I will definitely PM you :-)

Cheers

Nur eine kleine Anmerkung. Ich Denke, der in Ihrem Manual empfohlene Port 1935 UDP ist auch nicht ideal.
Der Port 1935 ist normalerweise der Standard Port für RTMP
Gut, wenn niemand RTMP benutzt, kann es für SRT funktionieren.
Habe es nicht getestet, da ich noch einen RTMP Server auf meinem PC verwende.


Just a small note. I think the port 1935 UDP recommended in your manual is not ideal either.
Port 1935 is usually the standard port for RTMP
Well, if no one is using RTMP, it can work for SRT.
Didn't test it as I still use an RTMP server on my PC.

List of standardized ports.

Well, if you say that, it will be so.
I have now looked at a few instructions, and none of them found a reference to port 1935 for SRT.


Port (Default 9710) - Port at which data is sent or pulled from. These ports must be open (outgoing or incoming) on your network for data to flow properly


In the use case described here the sender/source will run in calling mode reading UDP multicast from 224.0.0.1 port 2244 and writing SRT to hjortsberg.org on port 6600. The receiver will run in listening mode reading SRT from port 6600 and writing UDP multicast to 224.0.0.1 port 2255. So the UDP stream goes from caller to listener

Enter the port number (must be between 1 and 65535)

SRT_Alliance_Deployment_Guide

Seite 18

Had anyone of this group a funktional SRT Input connection with IPv6?

I tried Larix Boradcaster within local Network-Wifi wich works great.
Just send to srt://192.168.0.248:5000 also funktional settings for passphrase and keylenght.

I the tried to set to a local IPv6 address srt:[fe80::f4ef:c7f6:cfa2:67dc%4]:5000 but it wont work. fe80 Adresses are lokal subnet ipv6 only.


Why i tried that? Unfortunatly iam a cable docsis3.1 client wich is shared media and a bunch people share the publip ipv4 adress and iam not allowed to set any port forwarding.
Wich brought me to the idea to use an IPv6 Adress wich is unique in the internert. But it seem not to work in the local lan,

This leaves the question weather vMix is possible of recieving srt via IPv6 or does es just work ipv4 based. (it should work on both because after the nic resolution data is handled portwise in windows to the aplication)
But maybe an iphone is not capable of ipv6 wia wifi.

Has anyone a other solution of sending srt for testing?

Greetings Paul

Hello ask,

I have read this issue on github too. But i also questioned the larix team about this. The Larix replay was that this should work, but i also have the feeling they only inserted the srt framework in thier app.

Good to know.

Greetings Paul