AKAIK you can't do this. The LiveU Solo is an encoder, i.e. it takes the vMix output and sends to a CDN. It also currently doesn't support SRT (I have just upgraded to check). The simplest solution is to run vMix at both locations and then use either vMix call or SRT to connect both instances.

I have also done this in testing (not an actual broadcast) using an RTMP pull from Castr.io. Simply set up a custom rtmp in the LiveU browser interface to send the liveU encode to Castr.io. Then setup an rtmp pull input in vMix. If you use low latency mode, your delay could be as low as 5 seconds or so.

If he don't like our answers, he maybe go to do another else (like to do gardening). That device is for outside broadcasting and require a minimal knowledge about outside broadcast, routing and servers. Maybe all the noobs need to do a little research about broadcasting before to do what he want in this domain.

Learn more about Broadcasting, Live Streaming and all in this domain before write here.

Hai că ești prost de bubui, mai te și dai mare de căcăcios. Mai învață. Caută soluții și în altă parte, nu doar într-un singur program.

Wow, thanks everybody. Please don't get upset. I probably should add some information. I'm not really a stream or multicam noob. I just don't know how this works. So I use an ATEM switcher with matrix, tally and everything.

Later on I decided to use vMix for al my visuals and videos. vMix gets imported into a Ultrastudio4K which then is fill & key on the switcher. Now I'd like to stream live with a LiveU Solo+ to a rtmp source and pull that via vMix into my switcher. A little bit of latency shouldn't be a problem.

I started a castr trial because of your help, but I don't know what URL's should be put where. That's where the noob part starts.

Thanks everybody. I didn't want to create a discussion or anything :)

Greets,

Erik

Thanks for this. Are there pros/cons of using this approach (e.g. lower latency) vs. sending an RTMP stream to say Restream.io and then ingesting an RTMP Pull Link from Restream to vMix?

So last night I ran my vmix from the kitchen table mixing / graphics / remote commentary / Replay 1 camera / streaming to youtube with a LiveU solo as a main feed from the ground location. Used RTMP server as suggested above to transcode to NDI and then to vmix. The server software was running on a mac laptop with NDI Monitor for confidence. LiveU via twin 3G managed 8M from the ground, stream was sent to switchboard and then out to youtube ( safety no graphics unlisted) and my laptop running RTMP Server. 2hr Test. NDI Dropped out a few times during the game but recovered, not sure if I need to set the start delay / end delay settings within RTMP Server to help with this.
NDI was full resolution because I was using Replay and when I switched to low bandwidth to help with the failure Replay failed due to the wrong format.

The next test for me will be to be at the ground filming but controlling the kitchen table setup via my Skarrhoj controller. What I would like to do is travel to the location with my cameras and solo's but keep all the processing kit back in the kitchen self isolating, covid free.

Thoughts.

No. I haven't made contact with them yet. Perhaps I'll ask about the delays etc to see if that helps with the NDI stream.
I was wondering if I should be running the server software on the same PC as vmix ? rather than over the network. Thoughts ?
So that would mean the same PC is streaming and ingesting the RTMP feed.