vMix Forums
»
General
»
General Discussion
»
How To Display Outputs in Multiviewer
Rank: Newbie
Groups: Registered
Joined: 11/5/2023(UTC) Posts: 8 Location: Los Angeles Was thanked: 1 time(s) in 1 post(s)
|
Hi There-
I am using the multicorder to record 4 outputs, treating them as ISO records. Is there a way that I can set the multiview to display what outputs 1-4 are doing, similar to displaying what 4 hyperdecks are recording?
I've had a couple of instances where the outputs were not configured with the right sources and I recorded an episode. Had I been able to see what each "virtual" hyperdeck was recording, I would have caught the mistake.
Thanks! Matt
|
|
|
|
Rank: Advanced Member
Groups: Registered
Joined: 12/24/2021(UTC) Posts: 474 Location: athens Thanks: 118 times Was thanked: 68 time(s) in 64 post(s)
|
I think the most easy way to do this is to open ndi in the 4 outputs and then bring as inputs inside vmix output1-4 and assign these inputs in the multiview
|
|
|
|
Rank: Advanced Member
Groups: Registered
Joined: 1/23/2022(UTC) Posts: 91 Location: Milton Keynes Thanks: 13 times Was thanked: 4 time(s) in 4 post(s)
|
You could also dedicate a mix input for each Output 2-4, and instead of selecting which input is going to eahc output in Settings each time, just change the relevant mix.
Then have those inputs in the multiviewer. Saves saving NDI and means no video delay.
|
|
|
|
Rank: Advanced Member
Groups: Registered
Joined: 2/23/2019(UTC) Posts: 135 Thanks: 16 times Was thanked: 28 time(s) in 25 post(s)
|
Originally Posted by: spinfold You could also dedicate a mix input for each Output 2-4, and instead of selecting which input is going to eahc output in Settings each time, just change the relevant mix.
Then have those inputs in the multiviewer. Saves saving NDI and means no video delay. This is how I do it, also gives you transitions on outputs 2-4 rather than just cuts. You can either add these to the existing multiview or, if you want a view of just the four outputs: - Add an 'output input' to get output 1 in. Then add a four box view using layers and send that to a fullscreen output.
|
|
|
|
vMix Forums
»
General
»
General Discussion
»
How To Display Outputs in Multiviewer
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
Important Information:
The vMix Forums uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close