vMix Forums
»
General
»
General Discussion
»
"self render" and "FPS:" display
Rank: Newbie
Groups: Registered
Joined: 11/21/2011(UTC) Posts: 4 Location: mn, usa
|
What does the checkbox "self render" do? What is the meaning of the FPS: xx display reverting to zero and the Backup FPS: display reading a value?
Thanks
|
|
|
|
Rank: Administration
Groups: Administrators
Joined: 1/13/2010(UTC) Posts: 5,202 Location: Gold Coast, Australia Was thanked: 4260 time(s) in 1516 post(s)
|
When playing a video file or adding a camera input, these provide a constant stream of frames to vmix at a certain frame rate. (i.e 30 frames per second) This is what shows up in the FPS label.
If an input is static or paused, then vMix needs to generate the frames itself in order to make sure a recording does not have any dropped frames. This is what shows up in the Backup FPS label.
If an input has a lower or higher frame rate than the output (say a 25fps source but a 30fps output/recording) then you can untick Self Render to have the frame rate converted on the fly.
Hope this helps,
Regards,
Martin vMix
|
|
|
|
vMix Forums
»
General
»
General Discussion
»
"self render" and "FPS:" display
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
Important Information:
The vMix Forums uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close