vMix Forums
»
General
»
SRT
»
Audio Bussing to specific channels
Rank: Newbie
Groups: Registered
Joined: 11/7/2020(UTC) Posts: 1  Location: Great Lakes of America
|
Hello,
I am attempting to send my bus B to channels 3 and 4 as opposed to 5 and 6. I my External Audio output setting on MAB. I have gone into the main Settings Tab > Audio Outputs and Enabled A and B. I have set A to 1&2 and B to 3&4. Yet A always comes out on 3&4 and B always comes out on 5&6. Even if I just try switching B to 7&8 for experiments sake it still comes out on 5&6.
Anyone else dealt with this?
Cliff
|
|
|
|
|
|
Rank: Advanced Member
Groups: Registered
Joined: 1/25/2019(UTC) Posts: 284  Thanks: 16 times
Was thanked: 73 time(s) in 54 post(s)
|
|
|
|
|
|
|
Rank: Newbie
Groups: Registered
Joined: 6/4/2020(UTC) Posts: 6 Location: Madison, WI
|
As Far As I can tell, you cannot remap audio channels on SRT Outputs, the Mapping is as follows:
M L/R > 1/2
A L/R > 3/4
B L/R > 5/6
The workaround would be to swap bus A and B.
|
|
|
|
|
|
vMix Forums
»
General
»
SRT
»
Audio Bussing to specific channels
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
Important Information:
The vMix Forums uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
