Some of these may be repeats.

1) For a NDI input have an "auto low bandwidth mode". While in thumbnail or preview use low bandwidth mode to reduce network traffic. Once live go to full bandwidth, then switch back to low when no longer live. As NDI becomes the preferred input source this will become very helpful.

2) Provide a tally light in the upper right corner of PTZ inputs when the related camera is active. This warns the operator that selecting the input for preview will move a camera that is currently live.

3) When an overlay is on also put it on the preview pane so preview will show how it impacts the preview image.

4) Allow the line below the preview and live pane to move closer to the preview and live pane. The line indicates it can be moved, when the mouse is placed over it, but it does not stay when moved. This wasted space below the live and preview pane is needed for the more thumbnail input space.

5) Allow PTZ controls in the Basic HD version. A small nonprofit with a single PTZ input could then still do PTZ control. They are still limited to 4 inputs so not a threat that big users will benefit.

6) I suspect this has been ask for before, but allow the input region to be unpinned and moved to a 2nd monitor like the audio mixer can be moved. Even if this was required to be on the same graphics controller this would be a big help.

Thanks for considering.