vMix Forums
»
General
»
General Discussion
»
Using Dante input -monitoring
Rank: Advanced Member
Groups: Registered
Joined: 4/14/2015(UTC) Posts: 86 Location: Ottawa
Thanks: 1 times Was thanked: 5 time(s) in 2 post(s)
|
I have a Dante enabled mixer and am planning on sending this directly to my video rig with vmix. This will give me control of each channel of audio coming into the system, for granular control. What I am not sure of is how to monitor the signal for a headphone mix.
I need something with USB input only and a headphone jack for monitoring. I would like the sound of this to be as close to what is going out as possible.
Any ideas?
Thanks.
|
|
|
|
Rank: Advanced Member
Groups: Registered
Joined: 10/1/2016(UTC) Posts: 117 Thanks: 88 times Was thanked: 52 time(s) in 31 post(s)
|
Check out Dante VIA and Dante Controller software ... it may do what you need.
|
|
|
|
Rank: Advanced Member
Groups: Registered
Joined: 2/18/2014(UTC) Posts: 1,837 Location: Stockholm
Thanks: 144 times Was thanked: 297 time(s) in 250 post(s)
|
mikekay, You need to specify a little bit more about your audio setup. What do you mean by sending "this" and "monitor", for example do you need to Solo inputs at the mixer end or just listen to what vMix sends out.
|
|
|
|
vMix Forums
»
General
»
General Discussion
»
Using Dante input -monitoring
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
Important Information:
The vMix Forums uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close