vMix Forums
»
General
»
Feature Requests
»
Tally Lights with Arduino R3
Rank: Newbie
Groups: Registered
Joined: 11/27/2015(UTC) Posts: 7  
|
Hello there, I'm building at the time a controller for the Tally Light feature on vMix. When I use a Arduino Steuerplatien R3 board to which I have been playing a corresponding sketch (program). The experimental setup has been working. When connecting cable I use Cat7 network cable that I connect to the receivers. Once everything is ready I will post a few photos. Both the controller unit which is connected to a USB cable to the PC and the receiver unit are in an aluminum housing. For tips or suggestions for improvement, I am grateful. Gruss Didi KnightsTV attached the following image(s):  TallyLights3.JPG (311kb) downloaded 9 time(s). TallyLights4.JPG (321kb) downloaded 9 time(s). TallyLights5.JPG (473kb) downloaded 8 time(s). TallyLights1.JPG (367kb) downloaded 47 time(s). TallyLights2.JPG (314kb) downloaded 25 time(s).You cannot view/download attachments. Try to login or register.
|
|
|
|
|
|
Rank: Newbie
Groups: Registered
Joined: 11/27/2015(UTC) Posts: 7
|
Update KnightsTV attached the following image(s): TallyLights6.JPG (363kb) downloaded 11 time(s). TallyLights7.JPG (357kb) downloaded 9 time(s). TallyLights8.JPG (360kb) downloaded 8 time(s). TallyLights9.JPG (315kb) downloaded 6 time(s).You cannot view/download attachments. Try to login or register.
|
|
|
|
|
|
vMix Forums
»
General
»
Feature Requests
»
Tally Lights with Arduino R3
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
Important Information:
The vMix Forums uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
