Rank: Member
Groups: Registered
Joined: 3/28/2013(UTC)
Posts: 13
Location: Israel
Thanks: 3 times
|
Hi,
I'm running Vmix with 2 cameras. In addition to Vmix, I have another system - a logging system that should get a trigger (+5v OR dry contact) ONLY when Vmix starts RECORDING.
I thought to alter TALLY system to indicate RECORDING but didn't succeed.
Any help will be welcomed/appriciated.
Thanks,
Sharon
|
|
|
|
|
|
Rank: Advanced Member
Groups: Registered
Joined: 5/14/2013(UTC) Posts: 140  Location: uk Thanks: 2 times
Was thanked: 24 time(s) in 20 post(s)
|
I have managed to get an Arduino with an eathernet shield to monitor the recording status of v mix use it the XML from the API to drive some " ON AIR" lights , if I can find the code I will post there
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 3/19/2011(UTC) Posts: 28  Location: France Thanks: 1 times
|
Hi, I'm using an hardware command to start and stop the recording at distance. Actualy i have a keyboard chip with 2 butons connected to "R" to start recording and "S" to stop it. To have a visual for the state of recording i'm using a basic electronic flip-flop with a LED. The problem of this solution is the LED is not sync with vmix and if i have an electronic bug i can't be shure if the recording is realy start. I think the best solution is in the tally configuration where it could be possible to assign a pin to "rec state" (with the same arduino system than tally).
I don't know if it is easy to implement this to vmix ( Hi Martin !) but it would be a great.
Loïc (from France)
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
Important Information:
The vMix Forums uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close
