HI, i have a problem with the tallys of my brc-x400 cameras....
these are connected via visca over ip and everything seemed to go well until I noticed that the tallies, after a few seconds (12), went off even if the camera was still on air.
I tried searching online if anyone had the same problem but couldn't find anything.
the only thing I found is an official sony document that specifically talks about the commands of the visca protocol and, at a certain point it says:

"Expiration time for an on status of the tally
lamp
The tally lamp is turned off if not receiving an ON
command from any controller for 15 seconds
after receiving an ON command of TALLY ON/
OFF"


this is the link af the document:

https://www.sony.net/Pro..._Document/E042100111.pdf

if anyone has had the same problem please help me because i'm going crazy!

thanks

+1