Hello all.

I am new to vMix and have the following setup.

I have a Zoom L-8 interface connected to a PC via USB.

I have 3 Mics going into the L-8 via XLR on ch1,2,3.

In my vMix settings, under audio output I have my master output set to none and my headphones output set to Zoom L-8 ASIO Driver (channel 1&2).

On my L-8 I have channel 7 set to USB 1&2.

My desire here was to be able to monitor my mics and my monitoring from vMix both on the L-8 with one set of headphones.

My audio plays back through my PA correctly (which is sent over a Decklink Quad SDI output)

My vMix audio gets into the L-8 however it sounds wrong almost as if the audio bit rate is incorrectly set.

I have read over the L-8 manual but cant find any information on setting the audio bit rate, I am also unsure if this is actually the issue.

Any one had similar experience trying to use the L-8 as a capture and monitoring solution?

Thanks in advance.

Hello All

Thanks for getting back to me on this and sorry for the slow reply, I only just got round to testing your solution and that was the answer I was looking for. Fixed the issue I had no problem.

Thanks everyone, much appreciated.